Prepare the site:

1.  Rake away any leaf litter or existing mulch from the area you’re going to be planting.

2.  Dig a hole twice as wide and just as deep as the container. As you dig, pile the soil around the perimeter of the hole in at least two different areas. This makes it easier to backfill your shrub after planting.

3.  When the hole looks about right, use the shovel handle to gauge the depth of the hole and compare it to the depth of the container.

4.  Once they seem similar in depth, remove the shrub from its container by knocking briskly around the pot sides and bottom to loosen it, and carefully slide the plant out. Do not pull or yank on the stem(s). Alternatively, the pot can be cut away from the rootball with a pair of hand pruners.

 

Plant your shrub:

1.  Place the plant in the hole to check the depth. The top of the rootball should be even with or slightly above the soil surface. If it is too high, remove the plant and excavate a bit more. If it is too low, push in some soil from around the hole. Check again and repeat if necessary to achieve proper depth.

2.  Place plant in hole and step back. Does its best side face the direction from which the shrub will usually be viewed? Rotate the plant in the hole until you are happy with how it looks.

3.  Once you’ve decided on the most attractive side of your plant, use your hands to “rough up” the root ball a bit. The idea is to free them from the tight shape that the container has molded them into. Unwind any large, woody roots, and gently loosen the small roots away from the soil. This helps the plant become established more easily and quickly, so don’t forget this important step.

4.  Backfill using only the soil you excavated. As you backfill, firm the soil lightly around the roots to eliminate air pockets, continuing until you reach the top of the root ball, which should be covered with about ½” (1.27 cm) of soil.

​

Water and Mulch:

1.  Water your new shrub, making sure to thoroughly saturate the rootball and the surrounding soil. The best way to do this is to set your hose on a very low flow and leave it on for an hour or two. Apply the water at the edge of the rootball, and move the hose to different points around the plant a few times during this period.

2.  Most shrubs benefit from a 2-3” (5-7.6 cm) thick layer of shredded bark mulch applied over the entire root zone of the plant. This helps keep roots cool and conserves water, minimizing stress on your new plant and encouraging rapid development root development.

3.  Keep your new shrub well watered – it should not be allowed to dry out completely during its first season. In the coming months, the plant will mostly devote its energy to growing roots, so you may not see a lot of growth on top. Typically, shrubs begin to grow vigorously in their second season; growth and flowering increase every season as long as conditions remain favorable.